Data:
09.04|12:10
Radar RCWL-0516 senzor prezenta, miscare, sensor, ARM, 5V, Arduino 17,99 RON 44,95 RON Livrare in Bucuresti: - la domiciliu propriu (Str. Margeanului) - posta, curier ... Sector 5 Bucuresti Telefon validat azi Livrare in Bucuresti:
- la domiciliu propriu (Str. Margeanului)
- posta, curier e contra cost.
Livrare in tara:
- posta 15-30 lei
- fancourier 25-30 lei, cu verificare colet
Nota: Doar in cazul persoanele fizice (exceptie firma) nu se accepta plata numerar, restul metodelor de plata tip ramburs si online (cont ING, aplicatie plata mobil, revolut .... etc) sint perfect valabile.
- Cod produs: D448
Features
Equipped with RCWL-9196 chip supporting 4-28V wide voltage input, high level signal output when detecting the motion with active repeat trigger
360 degree no blind angle detection with 5-7m deteciting distance, the detection not affected by the surroundings, better performance than the IR sensor
Support night detecting function turn on /off, adjustable repeat trigger time and detecting distance by add the SMD components to the corresponding pins
Working Voltage: DC 4-28V, Board Size: 35.9 X 17.3mm/1.41 X 0.68inch
Specifications
Operating Voltage: 4-28V
Operating Current: 2.8mA (typical); 3mA (max)
Detection Distance: 5-9m
Transmitting Power: 20mW (typical); 30mW (max)
Output Voltage: 3.2-3.4V
Output Voltage Driving Capacity: 100mA
Trigger Way: repeat trigger
Output Control Low Level: 0V
Output Control High Level: 3.3V
Operating Temperature: -20 80 celsius
Storage Temperaturecelsius
Adjustment Part Introduction:
1.C-TM Adjust repeat trigger time,default trigger time is 2s;increasing capacitors capacity will make repeat trigger time longer;and actual counting trigger time can operate as below: Stick capacitor on C-TM,test 9196 3-pin frequency F,repeat trigger time T=(1/fR-GN Detection distance adjustment;connect with resistor and detection distance will become shorter;if not connect,detection distance is 7m;if connect with 1M ohm resistor,detection distance is 5m
3.R-CDS Internal VCC parallel connect with internal 1M ohm resistor to CDS pin (that is 196 9-pin) by R-CDS ,CDS connects with photoresistor,you can close detection function at night
Pin Definition:
3V3:3V3 power output
GND:ground
OUT:control output;when detect moving objects,it will output high level
VIN:input voltage,4-28V
CDS:enable control chip,lower than 0.7V,OUT will output low level all the time (5en50r al3x Publi24_1550242695